Description

Features of the S2 Filament Dryer New Update 2023 - The S2 filament dryer has been equipped with an additional hot air fan at the bottom to improve air circulation and ensure a more even temperature inside the housing. In addition, a new filament outlet has been added so you can freely choose the direction. This dryer helps to bring the filament effortlessly into the optimal condition for printing. Better Printing With Dry Filament - SUNLU S2 Filament Dry Box will remove excess moisture of 3D printing filament, which help you avoid common problems like clogging, poor adhesion and layer migration caused by the dampness of the filament. Heating More Evenly, Drying Faster - As an upgraded product, the S2 drying box adopts a double heating element structure, which heats up faster and evenly heat. Convenient Touch Screen Operation - Our Upgraded Filament Drying Box can adjust temperature (35~70℃) and time (1~99 hours) through the touch screen. After completing setting , the time, temperature, humidity and other indicators will be displayed on the screen in real time. Remember Your Operation - You can choose consumable code like PLA to jump to the corresponding default temperature and time, or adjust them you want. The settings before the shutdown will be remembered until you change settings again. Packing List 1* Filament Dryer 1* Adaptor 1* Instruction Remember Your Settings Double-click "ON/OFF" to enter the shutdown state. After restarting, the drying temperature, filament selection, and LED mode will retain the settings before the shutdown, and the drying time will be restored to the default 6 hours. High Compatibility Filament Dryer Our S2 Filament Dryer Box fits most normal filaments like PLA, PETG, TPU, ABS, etc.. You could try to choose corresponding Filament Code and it will set the proper temperature and time for your filament to dry. NOTE Before printing, it is recommended to bake it for ≥3 hours, and then print, the effect will be better. When the ambient temperature is low and the drying oven does not heat up to the set value, it is necessary to extend the baking time> 1 hour. It will have better printing effect when used with printer.